Page 1 of 1
is this a ploblem of exporter? or not?
Posted: Thu Feb 17, 2011 3:33 pm
by Daniel79
Yesterday i render this image but the image is wrong, the errors are only on the surfase of wall...is a problem of octane or is a wrong mesh o is a problem of exporter?
To night i try another setting but i don't know if the problem will solved..
I use the last version of octane whit cuda 3.0 win 7 and rhino exporter
Re: is this a ploblem of exporter? or not?
Posted: Thu Feb 17, 2011 3:43 pm
by SamPage
Daniel79 wrote:Yesterday i render this image but the image is wrong, the errors are only on the surfase of wall...is a problem of octane or is a wrong mesh o is a problem of exporter?
To night i try another setting but i don't know if the problem will solved..
I use the last version of octane whit cuda 3.0 win 7 and rhino exporter
Eech, that looks pretty bad. Any chance of getting the 3dm to look at to try and see what is going on? Is this Rhino 4 or 5?
Sam
Re: is this a ploblem of exporter? or not?
Posted: Thu Feb 17, 2011 3:48 pm
by Daniel79
It's rhino 5..whit the last version of octane and exporter..
i modeling a new wall and i hope it's all ok!
Re: is this a ploblem of exporter? or not?
Posted: Fri Feb 18, 2011 11:40 am
by Daniel79
Problem solved...i think is a problem of exporter:
when my model is locate in rhino too far from origin axis, this is the result!
Whe i move the same model to origin of axis all is ok..
Strange thing but now i can work!!