OTOY Forums

Brand new to Octane, so stupid simple question here - just not sure what I'm not understanding.

I'm just trying to test the Rounded edges rendering with a couple cubes. Currently using an Octane override which otherwise works fine. But When I bump up the 'Edges Rounding' value to anything between 0-1, nothing happens. What am I doing wrong? Is there something I need to plug into the Edges Rounding pin? Can't I just use the value in the Glossy Material node to adjust it?

Hi. Pls see the manual for how to render Round Edges. https://docs.otoy.com/#60Octane%202.0%20Features. The current Round Edges feature of Octane has some limitations, and Otoy have stated that they will be working on this during the Octane 3 release cycle.

Paul

I looked through the Modo plug-in manual before posting here. Couldn't seem to locate 'Edges Rounding' within it, perhaps I'm still just missing it.

The link you've posted sends me to the Rhinoceros manual. Could you show me where exactly this is addressed in the Modo one?

Hi everyone, sorry about that. our adms are busy fixing those links on the doc site. for now, please try here: Reference: https://docs.otoy.com/manuals/products/ ... -features/

Any updates on this? am on v4 now, and allthough the feature is both there in the interface and in the manual (on every material type page), I dont seem to get it working.

thnx guys,

sven

Hi Sven,
look at the new features of OctaneRender 2019.1 XB1 here:
viewtopic.php?f=33&t=70971
ciao Beppe

eactly what I am after.
can't wait for it

thnx

Sven