OTOY Forums

Posted: **Sun Sep 06, 2015 5:34 pm**

Hi everyone!
I can assign a mesh to a curve? ..with a modeling software and then,
create instances of the geometries that can be seen from octane.
You can do this?

What is the workflow?
Thanks!

Posted: **Sun Sep 06, 2015 6:28 pm**

I'm not entirely sure what you mean, but if you want to place mesh instances along a curve, I have that feature implemented in Phantom Scatter.

Posted: **Sun Sep 06, 2015 7:59 pm**

Phantom107 wrote:I'm not entirely sure what you mean, but if you want to place mesh instances along a curve, I have that feature implemented in Phantom Scatter.

I do not need a similar tool!

OTOY Forums

Assign a mesh to a curve with sofware modeling?

Assign a mesh to a curve with sofware modeling?

Re: Assign a mesh to a curve with sofware modeling?

Re: Assign a mesh to a curve with sofware modeling?