Page 1 of 1
navigation - material pool - a newbie question
Posted: Tue Dec 21, 2010 11:50 am
by pzdm
Hello everybody and sorry for my stupid questions.
1) How can I navigate material (node) pool (move etc?)
2) How can I disconnect a wire between two ports?
THX a lot and have a nice day, Pavel
Re: navigation - material pool - a newbie question
Posted: Tue Dec 21, 2010 12:14 pm
by matej
Hi!
1.) You cant, yet. I hope that at least panning comes in the next version, because we are running out of space
2.) Grab the 'wire' (anywhere) and move it away from the 'port'
Re: navigation - material pool - a newbie question
Posted: Tue Dec 21, 2010 2:48 pm
by pzdm
matej wrote:Hi!
1.) You cant, yet. I hope that at least panning comes in the next version, because we are running out of space
2.) Grab the 'wire' (anywhere) and move it away from the 'port'
THX a lot Matej
aha, it's a feature
, it reminds me Red Dwarf and Kryten as a man, aha, zooom
Re: navigation - material pool - a newbie question
Posted: Sun Dec 26, 2010 9:05 pm
by pzdm
hello everybody, it´s me again...
I work on Octane review for pixel magazine (czech/slovak printed cg magazine) and I have new questions, if I can...
1) Texture/material mirror is not supported? Tiling works without problem I have tested mirror and it does not work for me. Do you plan this feature in the future? It´s very usefull for wood samples for example.
2) how can I rename my own Macros?
3) can I drag and drop image (from outliner pool) to the material pool? Could I do the same for other nodes as well?
4) Do you plan copy/paste functions?
THX for your time, Pavel
Re: navigation - material pool - a newbie question
Posted: Sun Dec 26, 2010 9:33 pm
by pzdm
hmmm
sorry, I forgot...
Can I zoom (Ctrl -/+ in Photoshop for example) a contant of image pool? In case I want to see a whole composition...
Here is my first pretty easy test
Pavel
Re: navigation - material pool - a newbie question
Posted: Sun Dec 26, 2010 9:54 pm
by Proupin
yes you can zoom the canvas by pressing control+mouse wheel...
Re: navigation - material pool - a newbie question
Posted: Mon Dec 27, 2010 1:03 pm
by pzdm
THX a lot
yeah, Control works
And I found we can rename material in Node inspector pool...
P
Re: navigation - material pool - a newbie question
Posted: Tue Dec 28, 2010 10:03 am
by pzdm
A little sugestion....
is there a reason you have nodes from the top to the down? Maybe would be better to have it from the left to the right (my opinion). Is pretty terrible does not have a chance to see names of all ports. In second case there will be a space for it. I know name is how when mouse is over a port.
Here is my second example
Have a nice day, P