OTOY Forums

Hello,
I've been trying to render exact image size but no luck.
Using Octane 2.21 I can just figure out image resolution/Int Value
in the node.
I try locking ratio and try to fit render image viewport
size it goes back to default size.
Not sure if this really affects render time?
Is it possible to render specific dimension not showing
too much environment see attached image.
Cheer

Hi pinoy2, not sure I understand the question here. The viewport is just a viewport, you can zoom in and out, pan around etc, it shows whole or sections of the image that fits into the viewport, but ultimately the dimensions of the output .png or .exr image is the resolution. Octane renders up to the image resolution you have set for it. In your case, either adjust the resolution down to the size of the section you want rendered, or that section of the model has to be scaled up to the size of the resolution...

pinoy2 wrote:Hello,
I've been trying to render exact image size but no luck.
Using Octane 2.21 I can just figure out image resolution/Int Value
in the node.
I try locking ratio and try to fit render image viewport
size it goes back to default size.
Not sure if this really affects render time?
Is it possible to render specific dimension not showing
too much environment see attached image.
Cheer

Thanks for your help Abreukers,
All good now.