Page 1 of 1
jagged (aliasing problem again ...)
Posted: Tue Apr 07, 2015 7:34 pm
by Andygraph3D
Is it possible now with this last version of octane fixed this problem about jagged/aliasing problem WITHOUT use the "filter size" (with only all blured effect) or dubble size render and rescale ... ?
Re: jagged (aliasing problem again ...)
Posted: Wed Apr 08, 2015 8:30 am
by face_off
Hi - this is a general Octane issue - and I am not sure on it's status. Reducing the opacity of the emitter geometry may assist, as well and increasing filter size and/or resolution.
Paul
Re: jagged (aliasing problem again ...)
Posted: Wed Apr 08, 2015 10:51 am
by Andygraph3D
Thx Paul, i hope for a quickly solution from otoy for this annoying issue ...
Re: jagged (aliasing problem again ...)
Posted: Wed Apr 08, 2015 11:16 am
by face_off
I suggest you report it on the Octane Standalone 2.22.2 release thread, so that the Otoy devs see it.
Paul
Re: jagged (aliasing problem again ...)
Posted: Wed Apr 08, 2015 9:35 pm
by stratified
Hi,
Can you post some pictures so we can have a look?
edit: Is this the same problem as reported
here? If so you can kinda work around it until we released the fix.
cheers,
Thomas