Page 1 of 1
2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 3:49 pm
by Kerem
Whenever i enable passes my main render blooms up wat too much and get a wierd look. I don't know if i am repeating a post here but i really don't have to time to double check the forum before my deadline guys. Thank you.
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 4:08 pm
by inlifethrill
Are these results from picture viewer or live viewer?
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 4:11 pm
by Kerem
... picture viewer. Live is ok.
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 4:19 pm
by inlifethrill
A blind guess - go Octane Settings / Settings / Other and enable "Sync on geo updates". Additionally, copy/past everything into a new scene and try again. Create a new camera, from another point of view and see if it does it again. Enabling the multi-pass system shouldn't be related to this offset, at least in my knowledge.
Dobs
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 4:20 pm
by Kerem
Turns out i need to click post pass. Thanks for the approach thoug.
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 4:29 pm
by inlifethrill
Ehh, I did not realize you were worried about the glow that much. I was adressing the offset you were getting. Glad you found your way through.
Dobs
Re: 2.21.1 Enable pass issue
Posted: Wed Feb 25, 2015 7:01 pm
by Kerem
oh, that is my bad. just a fast editing of the sses'.