Page 1 of 1
2nd Car Design
Posted: Sat May 31, 2014 7:16 am
by treddie
Out of the few car designs of mine that I like, here's another one that seemed worth the while.
I'm going to leave the interior out of this one. So the windows will just be black. Should be a zippy fast render when ready.
Re: 2nd Car Design
Posted: Mon Jun 02, 2014 9:54 pm
by treddie
Thought I would post this, because it is kind of neat looking. A 3D printed unibody. Not that with today's technology, a big part like that could ever be built as fast as conventional metal stampers can churn out body panels. But hey! It's a car from the future where AAAAAANYTHING is possible!
Re: 2nd Car Design
Posted: Tue Jun 03, 2014 6:13 pm
by LudovicRouy
Your right, Big 3D printer already exist !
http://www.youtube.com/embed/15AmryIYu4k
Re: 2nd Car Design
Posted: Tue Jun 03, 2014 7:47 pm
by treddie
Now THAT's a 3D printer! I want one!
Re: 2nd Car Design
Posted: Sat Jun 07, 2014 10:22 am
by treddie
Almost ready for Octane. Just need to put mock floor and wheel wells in, and same old tires but new rims.
Re: 2nd Car Design
Posted: Sun Jun 08, 2014 8:51 am
by treddie
Only need to do the rims now, and then its UV time, which for this project will be virtually nill.
Re: 2nd Car Design
Posted: Mon Jun 09, 2014 7:43 am
by treddie
Last cheesy-render images before I start converting everything to objs for C4D and Octane:
Not sure I am going to keep that slatted vent thing over the rear engine compartment...Looks a lot like an '80s rear window shade. Might just go with a simple porous grate in its place.
Re: 2nd Car Design
Posted: Thu Jun 19, 2014 11:44 pm
by treddie