Page 1 of 1
Not showing .obj files to open
Posted: Tue Oct 12, 2010 2:55 am
by Manveer Dhillon
Hi,
I have a .obj file setup to open with Octane Render, however when I Add > Object > Mesh then go to select my .obj file from the directory it is not displaying the .obj file....or any .obj file that I have.
Why's this happening?
Re: Not showing .obj files to open
Posted: Tue Oct 12, 2010 4:54 am
by pixelrush
I'm not sure
You are using the Demo version I take it?
Which O/S do you have? Is Octane on the C: drive or somewhere else?
Can you navigate to and open the demo suite files?
Re: Not showing .obj files to open
Posted: Tue Oct 12, 2010 7:39 pm
by Manveer Dhillon
Yes I'm using the demo with Windows 7 64 bit installed. I've tried the 32bit and 64 bit versions but I'm getting the same problem. Ah well I'll just wait till I get the full version.
Re: Not showing .obj files to open
Posted: Tue Oct 12, 2010 7:47 pm
by pixelrush
Well it should run ok for you. A driver from the 197.xx series is suitable for the demo.
I vaguely remember someone with something like this before cos they had Octane in D: partition or something
