Page 1 of 1
Messed up material export on a very simple scene!
Posted: Mon Jun 17, 2013 4:01 pm
by Synthercat
I tried a simple test and got frustrated results... just 2 material with a sloppy created simple ball
Check out how it exports to Octane, TOTAL MESS!!! I even copy pasted the same ball 2 more times and
I get 3 different (!) balls on Octane!
Re: Messed up material export on a very simple scene!
Posted: Tue Jun 18, 2013 1:26 pm
by mib2berlin
Hi, upload the file so we can test, may on pastall.
Which Blender and exporter version?
http://www.pasteall.org/blend/
Cheers, mib.
Re: Messed up material export on a very simple scene!
Posted: Tue Jun 18, 2013 1:46 pm
by Synthercat
Ooops! I thought I did mate! Thanks for the heads up :
http://www.pasteall.org/blend/22192
Re: Messed up material export on a very simple scene!
Posted: Tue Jun 18, 2013 2:36 pm
by mib2berlin
Hi Synthercat, there are ~500 double faces on each sphere.
Remove doubles and recalculate normals help but still not 100 % clean mesh.
Add Edge Split modifierer, to get better mesh and may subdived 2 applied.
Blender 2.67a + Addon 1.21
Cheers, mib.
Edit: The spheres also very small, this can make problems in Octane too.
http://www.pasteall.org/blend/22194
Re: Messed up material export on a very simple scene!
Posted: Thu Jun 20, 2013 1:29 pm
by Synthercat
Double faces! What a rookie mistake! I can't believe I fell for that! I had tried Edge Split modifierer but didn't work due to double face I guess