OTOY Forums

virtual product shot using blender and octane. Same product shot every time, just new wraps, so all I do anymore is open the ocs file and load a new image for the wrap.

Being used here.

Nice.

You need to add the little slit that runs through the middle of the case (horizontally) in the ones lying in the back.

I'm pretty sure it's there in as much the case I modeled it off of is ( one of their actual products ), just not easily seen as it's just a thin line, so it doesn't really show up much, as their cases don't have an indented segment where the two cases meet. The sides just come together with a seam.

Sweet. More Vasst stuff. Just bought an NX5U and had some fun getting it working with vegas. Good render too.