OTOY Forums

I have two problems:
1
I do not speak English
2
Octane does not recognize the exact geometry built with the software Hexagon (DAZ).

I am attaching the pictures and thank you for the help.

From time to time there will be problems with meshes like these. If You want it to be shown nicely, you should have clean topology made of quads (4sided plogons). Now when you have n-sided surface it's just a matter of time when strange things might apear =) there's nothing so much of the problem, but You should learn a bit of clean modeling basics.

O.K.
Thanks for the quick response.
Bye.

For fast (not the best) solution, You can simply conect dots of these half circles around ( and divide these into to quads) so in the end You'll have one circle shaped with quads around - I believe this should solve Your problem =)

Cheers

Thank you.

Is O.K.
Grazie.