Re: 470GTX space test
Posted: Thu Oct 31, 2013 6:47 am
Hey!
I've been playing around with Leocad and Octane, hoping to get some nice renders for a project I'm working on. What steps did you take to do the Lego render that you posted?
I've tried exporting from Leocad as an .obj and then opening in Octane, but it results in some VERY fractured and faceted surfaces, especially if it's a printed part. Any tips to fix this?
Thanks!
I've been playing around with Leocad and Octane, hoping to get some nice renders for a project I'm working on. What steps did you take to do the Lego render that you posted?
I've tried exporting from Leocad as an .obj and then opening in Octane, but it results in some VERY fractured and faceted surfaces, especially if it's a printed part. Any tips to fix this?
Thanks!