Octane Sketchup Exporter - 1024-02 Tweet

[Area D]

i found the problem! (I use windows 7)

start.cmd doesn't work with mapped disk:

cd Z:\test\2\
start /MIN octane.cmd
exit
del "Z:\test\2\start.cmd"

with cd Z:\test\2\ cmd don't go in this directory, because it needs a "Z:"

cd Z:\test\2\
Z:
start /MIN octane.cmd
exit
del "Z:\test\2\start.cmd"

meanwhile if I use network ip:

cd \\192.168.1.252\SketchUp\3\
start /MIN octane.cmd
exit
del "\\192.168.1.252\SketchUp\3\start.cmd"

the command cd \\192.168.1.252\SketchUp\3\ doesn't work
in the CMD this is the error:

CMD does not support the use of UNC paths as current directories.

[TIG]

So you [we?] have found that you can run a cmd file in code if the project-folder in not on the drive that's running Windows - i.e. a mapped-drive, UNLESS you have the drive letter e.g. X: added to the code... I CAN do that - wait while I update the tool...

[Area D]

excuse me for my bad english

I should have said that "i found the problem on my pc "

thank you for your help,I'm looking forward to the next release!

[TIG]

Area D

Here's version 1024-03 that addresses the issue...
viewtopic.php?f=31&t=6643
Thanks for spotting it