Read about News and Updates regarding Octane Render in this forum.
For new users: this forum is moderated. Your first post will appear only after it has been reviewed by a moderator, so it will not show up immediately. This is necessary to avoid this forum being flooded by spam.
I would like o suggest what I think is an important revision to the material sphere (especially for the future). I would like to see either a progressive or stepped material thickness variation at the base of the sphere. There are quite a few variations of this as seen in competitors material spheres. Thanks!
one variation showing material thickness (important for translucency)
thickness_variation.jpg (19.46 KiB) Viewed 4846 times
actually i tested LW with demo, to understand its power. i can help you to write tutorial about interfacing of Octane with LightWave3D. i use Lw from many years,i wrote tutorials and articles on it in english and italian, over many magazines.