Hi Paul,
I got a cuda error 700 on slave
slave:
master:
Any idea?
greetz,
Moderator: face_off
face_off wrote:Hi Jeroen - perhaps there is an issue with the card or driver on that particular slave? Suggest making sure all the drivers are the same, and install Octane Standalone via the installer EXE to ensure the nvidia timeouts are correct. If you export that scene from ArchiCAD to Standalone and network render from there - does the error still occur?
Paul
rappet wrote:Hi Paul,
I also tried standalone 23.1 (instead of 24.2) and I get also the cuda 700 error on device 1 on slave when networkrendering.
Then I rendered on the machine with trouble on device one with the standalone to see if it only when using it as networkrendering.. and one gpu failes.
In log it says:
"CUda error on device 1: Errror code unknown
-> failed to unload module"
Might one GPU be broke, and shall I better post this issue in general forum?
greetz,
abstrax wrote:rappet wrote:Hi Paul,
I also tried standalone 23.1 (instead of 24.2) and I get also the cuda 700 error on device 1 on slave when networkrendering.
Then I rendered on the machine with trouble on device one with the standalone to see if it only when using it as networkrendering.. and one gpu failes.
In log it says:
"CUda error on device 1: Errror code unknown
-> failed to unload module"
Might one GPU be broke, and shall I better post this issue in general forum?
greetz,
Sounds like a hardware issue, but to be sure please send us the scene with which you can reproduce the issue and also the GPU model you are using.
face_off wrote:Jeroen - try under-clocking the faulty card.
Paul
Users browsing this forum: No registered users and 6 guests