OctaneRender® for ArchiCAD 3.03.3 [OBSOLETE] Tweet

[face_off]

I have updated the installers at the top of this thread with:

3.2.0.63
- Compiled with Octane 3.02

Paul

[s3d-weyrauch]

Small error: if I adjust the mid level of the displacement, than it occurs CUDA-error, and gives back silly values.
It works perfectly if I set it by an exact number manually.

This source doesn't contain any primitives!

O_160624_Displacement.JPG (25.86 KiB) Viewed 9675 times

Anyway, thanks for the features of Octane v3! And many many thanks for the floating license for the other developers as well!

[Scottiefeng]

I have updated the installers at the top of this thread with:

3.2.0.63
- Compiled with Octane 3.02

Paul

Hi Paul,

The Proxy editor stops doing real-time changes as previous version.

When you change the placement for translation, it does not happen to the viewport. You have to closed and editor and seer the result.

Thanks

[face_off]

The Proxy editor stops doing real-time changes as previous version.

Scottie - the only time the plugin changes the position of the proxy is when Face Camera is enabled.

Small error: if I adjust the mid level of the displacement, than it occurs CUDA-error, and gives back silly values.

This will be fixed in the next release.

Paul

[face_off]

This thread is now for the STABLE version of the plugin. The TEST release of the plugin can now be obtained from https://render.otoy.com/forum/viewtopic.php?f=56&t=55227 - pls subscribe to that thread.

Paul

[face_off]

I have updated the STABLE installer downloads at the top of this thread to release 3.3.3.66. Pls see the TEST thread for release notes.

[face_off]

This thread is now obsolete. Pls subscribe to https://render.otoy.com/forum/viewtopic.php?f=56&t=55227 for STABLE release builds.

Thanks

Paul