OTOY Forums

well I have installed following the instructions. Lightwave 11.6.1/ My octane menue is only showing the 4 dark boxes Octane render, Render target, Octane IPR,Octane tools<all are dark and unable to click on any of them to even enable octane as the instructions say????

well I got that figured out. But When I click on plugin options There is only one box (octanelive UserID that I can not even enter anything to activate my liscense.
Also When I click on about octane it says above(DEMO VERSION)

How to I get my liscense going here??????????????????

Hi Netstile,

Remove the demo, then go to the downloads page inside the customer area and get this install from there.

(don't forget to check out the manual too http://render.otoy.com/manuals/Lightwave3D/?page_id=39 - if you haven't already!)

Thanks
Chris.

That did the trick, I have been low on sleep and picked the wrong downloaded box and had installed the deomo by mistake. Thanks for your reply. Thanks

No problem...

Thanks
Chris.