OTOY Forums

These video are small examples for to do works Archicad correctly with Octane 0.81
There are some problem with archicad when create .obj file, it's good system to export the file in .3ds and after open the new file, for example with Blender and create the new file .obj
I am sorry for movies, they aren't good but I will do new movies with audio...
In these movie octane is use by internet this is the reason becouse it isn't fast.
this computer is about 50 Km from me...
see you and I am sorry for my mistakes...
http://www.vimeo.com/9858024
http://www.vimeo.com/9857812

Hi,

Thanks looks good, but why is the Octane Render navigation so terribly slow in the 2nd video ?

Radiance

HI!
becouse I was connect by internet with my Mac to PC through the software TeamViewer, the Pc was about 50 Km or 27 Miles from me.
The problem was TeamViewer... no Octane. Octane is Ok.

Tomorrow I will post the new video, only with octane and the file create with this exportation.
With this mode is possible to control every single part of the elements created with Archicad, glass, wall.
see you!!!

I have done a new video, but I must wait 2 hours and half for post...

This it's not special video... but we can see that with this tipology of exportation is possible to have the correct selection of the elements.
In this mode you can have "the same division in layer of Archicad"...
I tried a tree of xfrog... and I changed the resolution 1920*1080 and the render was very fast! the engine of Octane is very powerful!
http://vimeo.com/9918321

informations scene: 189614 Triangles 7.15 Megasamples/Sec 146 MB for this elaboration to 1920*1080

great framerate

are you leaving the video there ?
i'd like to add it to our videos page...

Radiance

Yes, Radiance... this is for you and for this community!

This video is not special, but we can see the fantastic performance of Octane render....this Pc i7 is 100% full and Octane render works without problem! it is fast! this is tecnology!
http://www.vimeo.com/9947510

This is a old work... section of bridge...about 6 year ago...I have created the bridge in Archicad .
282074 triangles...
this image it's not good I take it throughTeam Viewer by internet ... I had not time in this two days for test the beta...
I hope to post a new image with materials and use my beta Octane...