Page 1 of 1
Can we open Render Viewport window by command line
Posted:
Wed Jul 20, 2016 6:48 am
by xhm2855
when we want to launch Octane standlone and only show the 'render viewport' window , does Octane command-line support or it has another way?
Re: Can we open Render Viewport window by command line
Posted:
Thu Jul 21, 2016 3:28 pm
by bepeg4d
Hi xhm2855,
have you tried to save a workspace layout with just the Render View and then save it as default layout?
ciao beppe
Re: Can we open Render Viewport window by command line
Posted:
Fri Jul 22, 2016 7:44 am
by xhm2855
Hello, ciao beppe,
I followed your advice, and I can get a custom layout, and I attached it with this post. But if I just want to show the Render viewport, and disappear the scene outliner, nodegraph editor, and node inspector, How to do it?
Thanks,
Bootan
Re: Can we open Render Viewport window by command line
Posted:
Fri Jul 22, 2016 9:37 am
by bepeg4d
Hi,
if you right click on the little black square at the left of the panel title, you have several options, here you can also close a panel:
Do it for the panels except for the Render View and save the layout as default
ciao beppe
Re: Can we open Render Viewport window by command line
Posted:
Tue Jul 26, 2016 6:10 am
by xhm2855
Hello, Ciao.
You are correct. And can we hide the menu of Octane at the top of the window? I want to launch the octane just the orbx file with rendering and not hide all another things.
Bootan